GM Flywheel / Flex-plate for /262-350 CID 168 Teeth 14.13” OD w/Weight 1986-02

(No reviews yet) Write a Review
G142 FRA159
Does not apply

Flywheel diameter - 14.13 inches
Flywheel tooth count - 168 teeth
Flywheel has balance weight

This flywheel will not fit 1999 and up vehicles with the 4.3L Engine and the 300mm Torque Converter

More notes about the weight - GM engineers redesigned the crankshafts used in production small-block V8 and V6/90-degree engines in 1986 to use a leak-resistant one-piece rear seal. This change to a one-piece seal required a change in the bolt pattern on the crankshaft flywheel flange. The bolt circle on -1985 and earlier production crankshafts is 3.58" in diameter.

Later crankshafts have a 3.00" bolt circle. All cranks which use a one-piece seal must use a weighted flywheel. Flywheels and flexplates for these cranks are available in 12.85 inch and 14.13 inch diameters.

Vehicle Application
General Motors Automobiles and Trucks
1986 to 2002
Engine Sizes 4.3L, 5.0L, and 5.7L
This Flywheel is used in nearly 1000 different year model combinations.

This flywheel will NOT fit 1999 and up vehicles with the 4.3L Engine and the 300mm Torque Converter



When you purchase from Esco Automotive, you get a direct-replacement parts with the same or better performance as original-equipment Every part has been 100% Quality Checked to insure that you can install our part with confidence

Our goal is total customer satisfaction . In order to achieve this goal we offer only the highest quality parts at the most competitive prices with quick delivery.